GRAPHTEC FC9000 Series - Page 283

14-9
When using Cutting Master 4
1
In Adobe Illustrator, select "Cutting Master 4" - "Cut/Plot"
from the File menu.
In CorelDRAW, select "Launch" - "Cut/Plot (CM4)" from
the tool bar.
* If using CorelDRAW version X7 or earlier, select from
the application launcher.
Before selecting the Cut/Plot, set the layer of printing
data to Hide .
Supplement
The ROTATE can be set only when using
4POINTS.
For other registration marks, load the media
according to the orientation of the preview.
2
"Cut/Plot" screen is displayed.
Set the ROTATE to
to match the set direction of the
media.
Press the "Send".
Supplement
When the "Cut Contour" screen is displayed
IRUWKHÀUVWWLPHWKH$GG'HYLFHVFUHHQLV
displayed. Follow the instructions on the screen
to select the model name to use.

For USB connection, select the "Graphtec
USB".

For network connection, select the "TCP/IP"
and then enter the IP address of the cutting
plotter.