14-20
Step 5: Cut the printed media.
Using the cutting data saved in the USB memory in Step 4, cut the media prepared in Step 3 with the cutting
plotter.
Operation
Supplement
For loading media, see "Loading Media (Paper
or Marking Film)".
5-
1 Load the printed media on the cutting plotter.
G0100SYAA
G0100SYAC
Feed direction of media
Feed direction of media
MARK TYPE 1 MARK TYPE 2
5-
,QVHUWWKH86%PHPRU\WKDWVDYHGWKHÀOHLQWRWKH86%
memory slot of the cutting plotter.
5-
3 Set the menu of cutting plotter.
5-
4 Press the [PAUSE / MENU] key.
MENU screen is displayed.
Supplement
&RQÀUPWKDWWKH'HVWLQDWLRQLV86%PHPRU\
5-
5 Press the (
) key (LINK).
DATA LINK screen (1/2) is displayed.
www.delinit.by
To Next Page
Loading...
