14-22
Supplement
If the start mark cannot be scanned, check the
print result of start mark and the detect start
position etc.
5-
8 Using the the cutting plotter's POSITION (
) key, move
WKHWRROWRWKHVWDUWPDUNVHHÀJXUHXQGHUWKHEDUFRGHDQG
press the [ENTER] key.
The barcode is scanned, the corresponding data is read
out from the USB memory, and cutting starts when the
registration mark is completed to scan.
Feed direction of media
MARK TYPE 1 MARK TYPE 2
G0100SYAA
G0100SYAC
Feed direction of media
Move the center of
the tool here
Move the center of
the tool here
Feed direction of media
G01
Start mark
To Next Page
Loading...
