GRAPHTEC FC9000 Series - Page 299

14-25
3
Press the "Options".
Specify the length and thickness of the contour cut mark
on the displayed "Graphtec Mark Options" screen.
Check the "Use Barcode".
Select the "Roll Media" from the "Barcode Type".
The margins of the printer driver selected in the
DSSOLFDWLRQDUHLQLWLDOL]HGLQ3ULQWHU0DUJLQ:KHQ
changing the printer, acquire margin information by
pressing the "Get Printer Margins".
Press the “OK”.
Supplement
Registration marks are placed automatically.
The position cannot be changed.
4
Press the on the "DesignCentral" screen.
Registration mark and barcode are created on the design
screen.
G1100JMAA-R
G1100JMAA-F
G1100JMAA-R
G1100JMAA-F
Feed direction of media Feed direction of media
MARK TYPE 1 MARK TYPE 2
Barcode Barcode