GRAPHTEC FC9000 Series - Page 301

14-27
Step 3: Print design data.
After creating the design, print it on the media.
Supplement
Pay attention to the following when printing to prevent registration mark scan from failing when cutting.

Set the enlarge/shrink scale to 100%.

Set the printing position (center/lower left etc.) to "Not change".

In continuous operation, it is necessary that two or more data are printed on the roll media.
It is convenient to prepare printing and cutting data in advance and print them collectively.

Set the "Cross Cut" setting of the cutting plotter to OFF.

Print using the printer selected in "1. Prepare the design for data link (continuous operation)".
Operation
3-
1 See "14.1 Basic operation of printing and cutting" and print
the design with registration marks and roll media barcode for
printing and cutting.
Step 4: Save cutting data in data link server.
&UHDWHDMREÀOHDQGVDYHLWLQWKHGDWDOLQNVHUYHU
6LQFHFXWWLQJGDWDDQGEDUFRGHLQIRUPDWLRQDUHUHFRUGHGLQWKLVMREÀOHWKHFXWWLQJSORWWHUZLOOEHDEOHWRÀQGWKH
correct cutting data.
Operation
4-
 6DYHWKHÀOHIRUGDWDOLQNFRQWLQXRXVRSHUDWLRQLQWKH
personal computer (data link server).