14-32
When using Cutting Master 4
Supplement
The cutting plotter supports only one data link
server. Connecting multiple data link servers
to a single cutting plotter may not work
properly.
When using the data link server, do not use
USB connection and network connection at
the same time. Connect to the interface only
that uses the data link server.
When using a data link server with network
connection, always connect with a LAN cable.
When connecting with wireless (Wi-Fi), it may
not operate properly.
1
Click on the "Data Link" icon.
2
Each time the icon is clicked, start/stop of the datalink
server is switched.
In the start state, a red frame is displayed around the
icon.
<Mac><Windows>
StartStart Stop Stop
<Windows>
<Mac>
To Next Page
Loading...
