GRAPHTEC FC9000 Series - Page 309

14-35
Supplement
If the start mark cannot be scanned, check the
print result of start mark and the detect start
position etc.
7-
3 Using the POSITION ( ) key, move the tool to the black
UHFWDQJOHUHGIUDPHLQÀJXUHQH[WWRWKHEDUFRGH
G1100JMAA-R
G1100JMAA-F
G1100JMAA-R
G1100JMAA-F
Feed direction of media Feed direction of media
MARK TYPE 1 MARK TYPE 2
Move here Move here
Feed direction of media
Width of push roller
15mm
Align near the center of the width which is
the forward side of the start mark.
7-
 &RQÀUPWKHWRROSRVLWLRQDQGSUHVVWKH>(17(5@NH\
Barcode scanning starts, the corresponding data is read
from the personal computer, and cutting starts when the
registration mark scanning is completed.
,QFRQWLQXRXVRSHUDWLRQDIWHUFXWWLQJRIWKHÀUVWGDWDLV
completed, the cutting plotter automatically scans the
barcode, receive the data and repeat the cut without
having to perform the previous operation again.
* When media skews beyond the value set in "Skew
detection" of the cutting plotter, continuous operation is
stopped to prevent media misalignment .
For the "Skew detection", see the "Skew detection" in
Chapter 12.