15-8
5
Press the [1] key (BLADE WEAR DETECT.).
BLADE WEAR DETECT. screen is displayed.
6
Press the [1] key (ON) or the [2] key (OFF).
7
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\6(7
Setting will be confirmed and it will return to BLADE WEAR DETECT.
screen.
8
Press the [2] key (SET BLADE GROUP).
SET BLADE GROUP screen is displayed.
Supplement
You can set the range between 1 and 8.
9
Press the POSITION (
) key to select the Tool Condition
No. (CONDITION No.).
Supplement
You can set the range between 0 and 8.
When set to 0, the alarm will not belong to any
group.
10
Press the POSITION ( ) key and increase or decrease the
setting value.
11
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@6(7
6HWWLQJZLOOEHFRQÀUPHGDQGLWZLOOUHWXUQWR%/$'(:($5$/$50
SETUP screen
To Next Page
Loading...
