GRAPHTEC FC9000 Series - Page 345

16-23
5
Press the [3] key (DATA DUMP).
DATA DUMP start screen is displayed.
6
&RQÀUPWKDWWKHSHQWRROLVVHW
CAUTION
Do not place your hand around the moving
areas. The tool carriage will start moving, so
WKHUHLVDULVNRILQMXU\
7
&RQÀUPWKDWRSHUDWLRQDUHDRIWRRODQGPHGLDLVVDIH
Supplement
It will return to TEST screen without printing by
pressing the [ESC] key (CANCEL DATA DUMP).
8
Press the [1] key (DONE).
9
Send the cutting data.
The received cutting data (command) is output.
Supplement
It will keep on printing until the power is turned
off once the printing is started by pressing the [1]
key (DONE).
10
Turn the power off to stop the printing.