GRAPHTEC FC9000 Series - Page 54

2-28
Supplement
The screen below shows that the plotter is
currently detecting media.
When a rewinding device has been installed,
the following is displayed.
2
After the media is detected, the plotter is ready to receive
data for cutting or plotting. This status is called "READY
status" of the default screen.
:KHQVHWWLQJLVÀQLVKHGWKHWRROFDUULDJHVORFDWLRQZLOO
become the initial point.
If the interface or command settings have not been made,
make these settings before sending the data.
,IWKHVHWWLQJVKDYHEHHQPDGHWRRODGMXVWPHQWLVSHUIRUPHG
:KHQWKHSHQDGMXVWPHQWVKDYHEHHQPDGHWKHSORWWHULV
ready to start cutting.
Send the cutting or plotting data from the application
software.
Default screen is displayed.
Menu screen