8. To modify planned settings, do the following:
a) Select the network settings and click Edit.
The Edit IP Address dialog box opens.
b) Edit IP address settings as follows:
For network interface Control TeamSetting...
Control is requiredNetwork
Static is recommended.Address Allocation
The IP address for this interface on the network. Required.IP Address
For basic SAN network interface Media Connection #1Setting...
iSCSI (non-Redundant) is requiredNetwork
Static is required.Address Allocation
The IP address for this interface on the network. Required.IP Address
For redundant SAN network interface Media Connection #1Setting...
iSCSI (Primary Redundant) is requiredNetwork
Static is required.Address Allocation
The IP address for this interface on the network. Required.IP Address
For redundant SAN network interface Media Connection #2Setting...
iSCSI (Secondary Redundant) is requiredNetwork
Static is required.Address Allocation
The IP address for this interface on the network. Required.IP Address
102 K2 SAN Installation and Service Manual 02 February 2012
Planning and implementing a K2 SAN with SiteConfig
To Next Page
Loading...
