Configure New K2 System page 3 - Nearline K2 SAN
1. Review the information on this page and verify that you have correctly defined your K2 SAN.
For a 10G redundant nearline K2 SAN you should have the following:
• Two Gigabit Ethernet switches
• Two K2 Media Servers
2. Click Finish.
The Define New K2 Storage System wizard closes.
Your storage system appears in the tree view of the K2Config application.
Next, configure the server.
Configuring NH server - Part 1
1. In the K2Config application tree view, select [K2Server1].
For the basic nearline K2 SAN, this is the only NH server.
2. Click the Configure button.
The Configure K2 Server wizard opens to the Define server roles page.
192 K2 SAN Installation and Service Manual 02 February 2012
Configuring and licensing the K2 SAN
To Next Page
Loading...
