NOTE: Do not click Stop or Start unless you intend to manually control the current
primary/redundant roles. Using these buttons can trigger an automatic system recovery (failover)
event.
To launch Server Control Panel, in the K2Config application, click the Server Control Panel button.
On the local K2 Media Server, you must log in with administrator-level privileges in order to use
Server Control Panel.
Storage Utility for K2 SAN
There are two versions of Storage Utility:
• Storage Utility for the K2 SAN
• Storage Utility for stand-alone K2 systems
This section explains Storage Utility for the K2 SAN. Refer to the K2 System Guide to learn about
Storage Utility for stand-alone K2 Summit/Solo system.
NOTE: For shared storage, run Storage Utility only via the K2Config application.
The Storage Utility is your primary access to the media file system, the media database, and media
disks of the K2 SAN for configuration, maintenance, and repair. It is launched from the K2Config
application.
CAUTION: Use the Storage Utility only as directed by a documented procedure or by Grass
Valley Support. If used improperly, the Storage Utility can render your K2 system inoperable
or result in the loss of all your media.
268 K2 SAN Installation and Service Manual 02 February 2012
Overview of K2 Storage Tools
To Next Page
Loading...
