Configure File System Client Configuration page
This page connects the SAN client as a media file system client to the K2 Media Server taking the
role of media file system server. If there are redundant K2 Media Servers, both are listed on this
page as file system servers.
1. Verify that the K2 client is connecting to the correct K2 Media Server or Servers, as follows:
• For a basic (non-redundant) K2 SAN, the client connects to the only server.
• For a redundant K2 SAN, the client connects to server A as file system server 1 and server
B as file system server 2.
2. Click Check.
3. When the wizard reports that the configuration check is successful, click Next.
The iSCSI Initiator Configuration page opens.
238 K2 SAN Installation and Service Manual 02 February 2012
Configuring clients on the K2 SAN
To Next Page
Loading...
