GRASS VALLEY K2 - About IP Configuration of Network Interfaces on Devices

3. Configure the settings for the network as follows:
For media (iSCSI) networkSetting...
Ethernet is requiredType
StorageNetworking is requiredUsage
None is required for a basic (non-redundant) K2 SANRedundancy
Primary is required for a redundant K2 SAN media network A
Secondary is required for a redundant K2 SAN media network B
iSCSI (non-Redundant) is recommended for a basic (non-redundant) K2
SAN
Name
iSCSI (Primary Redundant) is recommended for a redundant K2 SAN
media network A
iSCSI (Secondary Redundant) is recommended for a redundant K2 SAN
media network B
Selected is requiredExclude from Host
Files
Selected is requiredManaged
The first (lowest) IP address in the range of IP addresses managed by
SiteConfig. Required.
Base IP Address
The number of IP addresses in the range managed by SiteConfig.
Required.
Number of Addresses
The network's subnet mask. Required.Subnet Mask
Not allowedGateway IP Address
Unselected is required. Related settings are disabled.Unmanaged
Not allowedDNS Servers
Not allowedDefault Interface
Name Suffix
4. Click OK to save settings and close.
About IP configuration of network interfaces on devices
You can perform IP configuration of network interfaces when working with a placeholder device
prior to discovery. When you add a device and choose a particular model, the model defines the
number, type and usage characteristics of network interfaces to expect on such a device.
You can view and edit each network interface and set up IP configuration selecting an appropriate
IP from the network to which each interface connects. The process for editing IP configuration
varies, depending on the device's phase.
02 February 2012 K2 SAN Installation and Service Manual 89
Planning and implementing a K2 SAN with SiteConfig