7. Verify media file system parameters.
Do not edit the configuration file for the media file system.
8. Click Accept.
A “…Please wait…” message box displays progress and a “…succeeded…” message confirms
the process is complete.
A message informs you that you must restart the server, however the restart at the end of the
Configure K2 Server wizard suffices, so you do not need to restart now.
9. Close the Storage Utility.
NOTE: Do not attempt to start SAN-attached systems or otherwise bring the SAN online until
instructed to do so by the documented procedure.
Next, continue with configuring the server using the K2Config application.
Configuring NH server A - Part 2
Configure File System Server Configuration page - NH server
Prerequisites for connected K2 RAID storage:
• Network and SNMP settings configured
• Disks bound
• New file system made
This page checks on the file system server role. The server also functions as a file system client,
which is also checked from this page.
1. In K2Config open the server's File System Server Configuration page, if the page is not already
open.
02 February 2012 K2 SAN Installation and Service Manual 221
Configuring and licensing the K2 SAN
To Next Page
Loading...
