Powering on/off a SAN client
As long as the K2 SAN remains operational, you can use the standard power on and power off
procedures appropriate for the SAN client. When a SAN client goes offline or comes online it does
not disrupt the K2 SAN.
However, if you are powering down or otherwise taking the K2 SAN itself out of service, you must
follow the correct SAN power down procedure. You must first stop all media access on your SAN
clients to ensure that they do not cause error conditions. You can power off the SAN clients or take
them offline using the K2Config application.
When powering up the K2 SAN, power on the SAN clients last so that they can verify their media
storage as part of their start up processes.
Taking a SAN client offline
1. Stop all media operations on the device. This includes, play, record, and transfer operations.
2. Shut down the SAN client.
242 K2 SAN Installation and Service Manual 02 February 2012
Configuring clients on the K2 SAN
To Next Page
Loading...
