2. In the K2Config application tree view, under the K2 Media Server select the File System Server
node.
The File System Server Configuration page appears.
3. Click Check and verify that the V: drive is shared.
Next, configure K2 clients and/or other iSCSI clients on the K2 SAN.
Configuring the basic nearline K2 SAN
Work through the topics in this section sequentially to configure a non-redundant nearline (Tier 3)
K2 SAN.
Prerequisites for initial configuration - Basic nearline K2 SAN
Before beginning your initial configuration, make sure the devices of the K2 SAN meet the following
prerequisites.
Control point PC
• Ethernet cable connected
• Control Point software installed
• Control network IP address assigned
• Network communication over the control network with all other K2 devices
• Power on
Ethernet switch
• Ethernet cables connected
• Control network IP address assigned
• VLANs set up
• Trunks set up
• Power on
K2 Media Server
• Ethernet cables connected
• Fibre Channel cable connected
• Software installed, as from the factory, including QuickTime 7
• Control network IP address assigned
• Power on for all servers
K2 RAID chassis
• Fibre Channel cable(s) connected
• Ethernet cable(s) connected
02 February 2012 K2 SAN Installation and Service Manual 187
Configuring and licensing the K2 SAN
To Next Page
Loading...
