3. Configure the settings for the network as follows:
For control networkSetting...
Ethernet is requiredType
Control is requiredUsage
None is required. This is true even on a redundant K2 SAN. (Only the
iSCSI network is redundant on a redundant K2 SAN.)
Redundancy
Control is recommendedName
Unselected is requiredExclude from Host
Files
Selected is requiredManaged
The first (lowest) IP address in the range of IP addresses managed by
SiteConfig. Required.
Base IP Address
The number of IP addresses in the range managed by SiteConfig.
Required.
Number of Addresses
The network's subnet mask. Required.Subnet Mask
Additional network settings managed by SiteConfig. Allowed.Gateway IP Address
Unselected is required. Related settings are disabled.Unmanaged
Servers providing DNS for name resolution. Allowed.DNS Servers
Not allowedDefault Interface
Name Suffix
4. Click OK to save settings and close.
Modifying the FTP/streaming network
1. In the Network Configuration | Networks tree view, select the K2 SAN's Site node.
The networks under that node are displayed in the list view.
02 February 2012 K2 SAN Installation and Service Manual 85
Planning and implementing a K2 SAN with SiteConfig
To Next Page
Loading...
Need help?
General