GRASS VALLEY K2 - Installing the Discovery Agent on a K2 Media Server

Activating the Windows operating system on page 123
Setting up Windows on page 123
Restoring network configuration on page 289
Installing the Discovery Agent on a K2 Media Server on page 122
Installing the Fibre Channel card driver on page 296
Activating the Windows operating system on page 123
Installing the Discovery Agent on a K2 Media Server
If the device that you plan to manage with SiteConfig does not have a SiteConfig Discovery agent
installed, use this topic to verify and, if necessary, manually install SiteConfig support software.
Doing so allows SiteConfig to discover and manage the device. If the device has any version of the
SiteConfig Discovery Agent currently installed, you should use SiteConfig to upgrade the Discovery
Agent, rather than installing it manually.
1. On the device you plan to manage with SiteConfig, open the Windows Services Control Panel
and look for the following required item:
• ProductFrame Discovery Agent
2. Proceed as follows:
• If you find the required items, no further steps are necessary. SiteConfig support software is
installed.
• If a required item is not present, navigate to your SiteConfig files. If you do not already have
these files in convenient location, you can find them on the PC that hosts SiteConfig, in the
SiteConfig install location. Then continue with next steps as appropriate.
3. To launch the program that installs the ProductFrame Discovery Agent Service do the following:
a) Copy the Discovery Agent Setup subdirectory to the device.
b) In the Discovery Agent Setup directory, double-click the
DiscoveryAgentServiceSetup.msi file.
The setup program launches to install the SiteConfig Discovery Agent.
c) Follow the setup wizard.
4. When presented with a list of device types, select the following:
• K2Server
5. Complete the setup wizard and restart the device.
The restart is required after the installation.
122 K2 SAN Installation and Service Manual 02 February 2012
Managing K2 Software