Configuring K2 software deployment
Take the following into consideration when using SiteConfig to deploy K2 SAN software.
• You typically configure one deployment group for K2 clients and one deployment group for K2
Media Servers. This allows you to target and sequence software deployment tasks to the different
types of devices.
• You typically upgrade K2 Media Servers first, then K2 Media Clients.
• Always follow detailed steps in K2 Release Notes for the version of software to which you are
upgrading.
Use the following topics to manage software deployment on a K2 SAN.
Configuring deployment groups
Prerequisites for this procedure are as follows:
• The device is assigned in the SiteConfig system description and network connectivity is present.
1. In the Software Deployment | Deployment Groups tree view, right-click the top node and select
Add Deployment Group.
A deployment group appears in the tree view.
2. Right-click the deployment group, select Rename, and enter a name for the deployment group.
3. Right-click the deployment group and select Add Target Device.
The Add Target Device(s) wizard opens.
4. In the Available Target Devices tree view, select the node that displays the devices that you are
combining as a deployment group.
114 K2 SAN Installation and Service Manual 02 February 2012
Managing K2 Software
To Next Page
Loading...
Need help?
General