GRASS VALLEY K2 - Configure Page 1 - K2 Client

3. In the K2Config application tree view, verify that the K2 SAN has the correct number of clients,
according to your system design.
If the correct number of clients is not currently added to the K2 SAN, you can add or remove
clients now (before clients are configured), as follows:
• To add a client, select the top node of the storage system and click the Add Device button.
• To remove a client, select an unconfigured client and click the Remove button.
4. In the K2Config application tree view, select the system you are adding to the K2 SAN.
5. Select a client and click the Configure button.
The configuration wizard opens to page 1.
NOTE: If your system has a large number of iSCSI clients, you are prompted to restart the server
that has the role of SNFS file system server when you configure clients and cross the following
thresholds: 64 clients; 80 clients; 96 clients.
Related Topics
Enabling and disabling the write filter using K2Config on page 305
Configure page 1 - K2 client
1. Enter the IP address or network name for a SAN client, as currently configured on the client
system.
You should configure your highest bandwidth SAN clients first, as this ensures load balancing
is correct.
2. For the Storage Access settings, leave iSCSI selected.
3. Click Next.
234 K2 SAN Installation and Service Manual 02 February 2012
Configuring clients on the K2 SAN