GRASS VALLEY K2 - Upgrading Firmware on HP Switch

4. In the switch’s configuration application, choose Configuration, then Device Features.
5. Set Spanning Tree to On and click Apply Changes.
If prompted, log in with the switch’s administrator username and password.
6. Close the switch configuration application.
7. Restart the switch to put changes into effect.
Upgrading firmware on HP switch
1. If you have not already done so, install a TFTP Server.
For example, to install tftpd32.exe, go to http://tftpd32.jounin.net/.
2. Open the TFTP Server.
3. Make sure your current working directory includes the *.swi file that you are using for the
upgrade.
4. Execute the copy command with the following syntax:
copy tftp flash <ip-address> <remote-os-file> [ < primary | secondary
> ]
Note that if you do not specify the flash destination, the TFTP download defaults to the primary
flash.
For example, to download a software file named T_13_23.swi from a TFTP server with the IP
address of 10.16.34.3 1, use the following:
ProCurve # copy tftp flash 10.16.34.3 T_13_23.swi
5. When prompted The primary OS image will be deleted. continue [y/n]?, press
Y.
When the switch finishes downloading the software file from the server, it displays the progress
message Validating and Writing System Software to FLASH...
338 K2 SAN Installation and Service Manual 02 February 2012
Administering and maintaining the K2 SAN