6. Restart the K2 Media Server.
A startup screen displays the message “Warning: Detected mode change from SCSI to RAID on
ChA of the embedded RAID system.”
7. Select Yes.
A startup screen displays the message “Warning: Detected mode change from SCSI to RAID on
ChB of the embedded RAID system.”
8. Select Yes.
The K2 Media Server restarts as normal.
When startup completes, normal operation is restored.
Checking K2 Media Server services
The following table specifies the startup type of services for the different K2 Media Server roles.
Depending on a K2 Media Server's roles, some services have different startup types. Unless otherwise
noted, services with startup type Automatic are started, while services with startup type Manual or
Disabled are not started. You can use this table to check services if you suspect that they have been
tampered with or for any reason are not set correctly.
To reset services, reconfigure the server with the K2Config application, starting at the beginning
of the configuration wizard. Do not manually change the way services run on a configured K2 Media
Server.
NAS serverFTP serverMetadata serveriSCSI bridgeSNFS file system
server
Service
AutomaticAutomaticManualAutomaticAutomatic
2
*CvfsPM
1
AutomaticAutomaticAutomaticAutomaticAutomaticGrass Valley
AppService
ManualManualManualManualManualGrass Valley
Extent Manager
Service
ManualAutomatic
3
ManualManualManual*Grass Valley
FTP Dameon
ManualManualManualManualManualGrass Valley
Import Service
AutomaticAutomaticAutomaticAutomaticAutomaticGrass Valley K2
Config
2
This startup type is top priority for servers with this role. In other words, if a server has this role, then this is always the
service’s startup type, regardless of other roles that specify a different startup type.
1
With SNFS version 3.5, this is the only service. Previous versions had StorNext File System service and StorNext File
System RPC Port Mapper service
3
This startup type is top priority for servers with this role. In other words, if a server has this role, then this is always the
service’s startup type, regardless of other roles that specify a different startup type.
02 February 2012 K2 SAN Installation and Service Manual 297
Administering and maintaining the K2 SAN
To Next Page
Loading...
