• New file system made
This page checks on the configuration of the K2 Media Server in one of its main roles as a file
system server. The K2 Media Server also functions as a file system client, which is also checked
from this page.
1. In Storage Utility open the server's File System Server Configuration page, if the page is not
already open.
2. If you have not already done so, enter the name or IP address of the redundant K2 Media Server
(server B).
3. If desired, configure reference file generation.
4. Click Check.
5. When the wizard reports that the configuration is correct, click Next.
If you get a “The V: will not be available until this device is rebooted…” message, you can safely
continue now and reboot later when instructed to do so.
The iSCSI Bridge Server Configuration page opens.
Related Topics
Configuring reference file type on a K2 SAN system on page 280
170 K2 SAN Installation and Service Manual 02 February 2012
Configuring and licensing the K2 SAN
To Next Page
Loading...
Need help?
General