• The restart of server A after it is configured is complete
After you have configured the first K2 Media Server (server A) you next configure the redundant
K2 Media Serer (server B).
1. Verify that server A has restarted by opening the MS-DOS command prompt and use the “ping”
command.
2. In the K2 System Configuration application tree view, select the K2 Media Server you are
configuring as server B.
3. Click the Configure button.
The Configure K2 Server wizard opens to the Define server roles page.
Configure Define Server Roles page - Redundant K2 SAN server A and server B
1. Enter the name for the K2 Media Server, as currently configured on the machine.
2. Enter the name or IP address of the Ethernet switch, as currently configured on the switch, to
which the K2 Media Server is connected.
3. Select all roles, except as follows:
If the K2 SAN has one or more optional NH servers, then FTP traffic should go to the NH server,
not the K2 Media Server you are now configuring. In this case, do not select the FTP server role
or the NAS server role
4. Click Next.
The Software Configuration page opens.
174 K2 SAN Installation and Service Manual 02 February 2012
Configuring and licensing the K2 SAN
To Next Page
Loading...
