GRASS VALLEY K2 - Page 291

4. Reconcile the locations assigned to the adapter names with the names as currently configured in
the Name column as follows:
• On systems with no 10 Gig network interface card installed, the required mapping of names
to locations is specified as follows:
Must be named as follows:The adapter name (as displayed in the Device
Name column) that is assigned to this
location…
Control ConnectionPCI bus 1, device 0, function 0
FTP-Streaming ConnectionPCI bus 1, device 0, function 1
Unused Connection 1PCI bus 2, device 0, function 0
Unused Connection 2PCI bus 2, device 0, function 1
• On systems with a 10 Gig network interface card installed, the required mapping of names
to locations is specified as follows:
Must be named as follows:The adapter name (as displayed in the Device
Name column) that is assigned to this
location…
Control ConnectionPCI bus 1, device 0, function 0
Unused Connection 0PCI bus 1, device 0, function 1
Unused Connection 1PCI bus 2, device 0, function 0
Unused Connection 2PCI bus 2, device 0, function 1
FTP 10G ConnectionPCI bus 5, device 0, function 0
The 10 Gig network interface adapter must be named FTP 10G Connection. If it has
dual-ports, name the other connection Unused Connection 3 10G.
5. Proceed as follows:
• If all the names on this system are configured correctly to locations, skip the rest of this
procedure.
• If names on this system are not configured correctly to locations, for each adapter name
incorrectly configured, complete the remaining steps of this procedure.
6. Select the name in the Name column.
7. Select File | Rename to enter rename mode.
8. Type the name required for the location.
Next, reorder adapters.
Reorder adapters
Before beginning this task, make sure of the following:
• Adapters are named correctly according to their PCI bus location
• The control team is created
02 February 2012 K2 SAN Installation and Service Manual 291
Administering and maintaining the K2 SAN