12. In the Create a Zone dialog, enter Zone2 as the name for the new zone, and click the OK button.
The new zone name is displayed in the Zone Sets tree.
13. Click the Apply button. In the Save Zoning & Error Check dialog, click Save Zoning, then Yes,
OK, and Close on subsequent message boxes.
You can ignore a "Error activating zone set" message.
14. When a zone is created, its zone type is soft. For Zone1 and Zone2, change the zone type to a
hard zone as follows:
a) In the Zone Sets tree, right-click the zone and select Set Zone Type from the popup menu.
b) In the Set Zone Type dialog, open the Zone Type pull-down menu and select ACL, then click
the OK button.
c) Repeat steps for the other zone.
15. In the Port/Device tree on the right of the Edit Zoning dialog box, select ports 0 - 7 (Shift + Click)
and drag them into the Zone1.
16. Click the Apply button. In the Save Zoning & Error Check dialog, click Save Zoning, then Yes,
OK, and Close to save changes to the zoning database.
17. In the Port/Device tree on the right of the Edit Zoning dialog box, select ports 8 - 15 (Shift +
Click) and drag them into the Zone2.
350 K2 SAN Installation and Service Manual 02 February 2012
Custom K2 SAN systems
To Next Page
Loading...
