8. If you do not need trunks, such as on a one-switch system, skip to the next step in this procedure.
If you need trunks, such as on a two-switch system with ISLs, do the following:
a) Select (Ctrl + Click) the trunked ports. Typically the trunked ports are at the bottom of the
list and are labeled Trk1.
b) Click Modify Selected Ports.
If prompted, log in as administrator.
c) For the trunked ports, set Port Enabled to Yes. On some switch models, some ports are disabled
by default, so make sure you enable them. Leave Mode as default of Auto.
d) Set Flow Control as follows:
Set to Disable.
e) Click Apply Settings.
9. On the Port Configuration page, do one of the following:
• If you do not have trunks, select all ports.
• If you have trunks, select the remaining ports (the ports not trunked).
02 February 2012 K2 SAN Installation and Service Manual 69
Setting up the K2 SAN infrastructure
To Next Page
Loading...
