What to do if Guldmann Mobility Aid shows fault 18/22?
If your Guldmann Mobility Aid displays fault 18/22, indicating a hardware overcurrent on the leader of the twin hoist (18), you should consider: Replacing the motor (18). If the issue persists, replace the PCB (18).
What to do if Guldmann Mobility Aid is not charging 17?
If your Guldmann Mobility Aid is not charging (17), and the issue is with the follower charger, here’s what to check: * Check the connection between the two charger PCBs (J2 to J2). * Check the connection between the charger PCB (J4) and the motor safety PCB (J20 on 17). * Check the connection between the battery and charger (J3). If these steps don't resolve the issue, change the charger PCB.
What to do if Guldmann Mobility Aid shows fault 81/1?
If your Guldmann Mobility Aid displays fault 81/1, indicating a communication fault with the Com module (81), you can try the following: * Check the cables and connection to the Com module (J105 or J5 on 81 to J2 on 16). * Check the jumper setting on (81). * If problems persist, replace (81).
What to do if Guldmann Mobility Aid shows fault 82/1?
If your Guldmann Mobility Aid displays fault 82/1, indicating a communication fault with the Com module follower twin hoist (82), you should: Check the cables and connection to the Com module (J105 or J5 on 82 to J2 on 18). Check the jumper setting on (82). If the problem persists, replace (82).
What to do if Guldmann Mobility Aid shows fault 32/1?
If your Guldmann Mobility Aid displays fault 32/1, indicating a communication fault with the Aux drive motor (32), here’s what to do: * Check the cables and connection to the aux module (J2 on RS485 to J3 on 16). * Check the Jumper setting on (32). * If the issue persists, replace (32).
Basic terms, legal aspects, and general guidelines for use and handling.
Details on hoist models, configurations, and available rail system types.
Step-by-step instructions for servicing and repairing the GH3 hoist.
Step-by-step instructions for servicing and repairing the GH1 hoist.
Illustrated lists of spare parts for various hoist models.
Schematics for hoist configurations, including jumper settings.
Procedures for periodic safety inspections according to standards.
Safety procedures for inspecting lifting slings.
General| Type | Ceiling Hoist |
|---|---|
| Lifting Speed | 0.12 m/s |
| Max Speed | 0.12 m/s |
| Control Type | Handheld Control |
| Safety Features | Emergency stop, overload protection |
To Next Page
