1-7
z Device downloads a startup file from PC for device upgrade, and uploads the configuration file to
PC for backup.
z On PC, an FTP user account has been created for the FTP client, with the username being abc
and the password being pwd.
Figure 1-2 Network diagram for FTPing a startup file from an FTP server
Configuration procedure
If the available memory space of the device is not enough, use the fixdisk command to clear the
memory or use the delete /unreserved file-url command to delete the files not in use and then perform
the following operations.
# Log in to the server through FTP.
<Sysname> ftp 10.1.1.1
Trying 10.1.1.1
Connected to 10.1.1.1
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(10.1.1.1:(none)):abc
331 Give me your password, please
Password:
230 Logged in successfully
# Set the file transfer mode to binary to transmit startup file.
[ftp] binary
200 Type set to I.
# Download the startup file newest.bin from PC to Device.
[ftp] get newest.bin
# Upload the configuration file config.cfg of Device to the server for backup.
[ftp] ascii
[ftp] put config.cfg back-config.cfg
227 Entering Passive Mode (10,1,1,1,4,2).
125 ASCII mode data connection already open, transfer starting for /config.cfg.
226 Transfer complete.
FTP: 3494 byte(s) sent in 5.646 second(s), 618.00 byte(s)/sec.
[ftp] bye
# Specify newest.bin as the main startup file to be used at the next startup.
To Next Page
Loading...
Need help?
General