H3C S5120-SI Series Configuration Guide

1-13
Rebooting a member device
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
—
Reboot a specified member
device
reboot member
{ member-number |
mac-address mac-address }
[ eraseflash ]
Required
Configuring the Member Devices
Enabling NDP
Refer to Enabling NDP Globally and for Specific Ports.
Enabling NTDP
Refer to Enabling NTDP Globally and for Specific Ports.
Manually Collecting Topology Information
Refer to Manually Collecting Topology Information.
Enabling the Cluster Function
Refer to Enabling the Cluster Function.
Deleting a Member Device from a Cluster
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
—
Delete a member device from
the cluster
undo administrator-address
Required
Configuring Access Between the Management Device and Its
Member Devices
After having successfully configured NDP, NTDP and cluster, you can configure, manage and monitor
the member devices through the management device. You can manage member devices in a cluster
through switching from the operation interface of the management device to that of a member device or
configure the management device by switching from the operation interface of a member device to that
of the management device.
Follow these steps to configure access between member devices of a cluster:

H3C S5120-SI Series Specifications

General

Brand	H3C
Model	S5120-SI Series
Category	Switch
Language	English