H3C S5120-SI Series Configuration Guide

1-3
Displaying and Maintaining HABP
To do… Use the command… Remarks
Display HABP configuration information
display habp
Available in any
view
Display HABP MAC address table
entries
display habp table
Available in any
view
Display HABP packet statistics
display habp traffic
Available in any
view
HABP Configuration Example
Network requirements
As shown in Figure 1-2, Switch A is the management device and connects two access devices: Switch
B and Switch C. Configure HABP so that Switch A can manage Switch B and Switch C.
z Configure Switch A as the HABP server, allowing HABP packets to be transmitted in VLAN 2.
z Enable HABP client on Switch B and Switch C.
z On switch A, set the interval to send HABP request packets to 50 seconds.
Figure 1-2 Network diagram for HABP configuration
Configuration procedure
1) Configure Switch A
# Configure the IP addresses of the involved interfaces. (Omitted)
# Enable HABP.
<SwitchA> system-view

H3C S5120-SI Series Specifications

General

Brand	H3C
Model	S5120-SI Series
Category	Switch
Language	English