H3C S5120-SI Series

5-5
To do… Use the command… Remarks
Configure SP queuing
undo qos wrr
Optional
The default queuing algorithm on an
interface is SP queuing.
Configuration example
1) Network requirements
Configure GigabitEthernet 1/0/1 to adopt SP queuing.
2) Configuration procedure
# Enter system view
<Sysname> system-view
# Configure GigabitEthernet1/0/1 to adopt SP queuing.
[Sysname]interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo qos wrr
Configure WRR Queuing
Configuration procedure
Follow these steps to configure basic WRR queuing:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter
interface
view
interface interface-type
interface-number
Enter
interface
view or port
group view
Enter port
group view
port-group manual
port-group-name
Use either command
Settings in interface view take effect
on the current interface; settings in
port group view take effect on all ports
in the port group.
Configure a WRR queue
qos wrr queue-id group
group-id weight
schedule-value
Required
The default queuing algorithm on an
interface is SP queuing.
Display WRR queuing
configuration information
on interface(s)
display qos wrr interface
[ interface-type
interface-number ]
Optional
Available in any view
To guarantee that WRR correctly schedules queues according to their weights, make sure that the
queue IDs in each WRR group are contiguous.
Configuration example
1) Network requirements
z Enable WRR queuing on the interface.