1-11
To do… Use the command… Remarks
Configure the output rules of
the system information
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log
{ level severity | state state } * |
trap { level severity | state
state } * ] *
Optional
Refer to Default Output Rules
of System
.
Configure the format of the time
stamp
info-center timestamp
{ debugging | log | trap }
{ boot | date | none }
Optional
The time stamp format for log,
trap and debugging information
is date by default.
Outputting System Information to the Log Buffer
You can configure to output log, trap, and debugging information to the log buffer, but the log buffer
receives the log and debugging information only, and discards the trap information.
To do… Use the command… Remarks
Enter system view
system-view
—
Enable information center
info-center enable
Optional
Enabled by default.
Name the channel with a
specified channel number
info-center channel
channel-number name
channel-name
Optional
Refer to Table 1-2
for default
channel names.
Configure the channel through
which system information can
be output to the log buffer and
specify the buffer size
info-center logbuffer
[ channel { channel-number |
channel-name } | size
buffersize ] *
Optional
By default, system information
is output to the log buffer
through channel 4 (known as
logbuffer) and the default buffer
size is 512.
Configure the output rules of
the system information
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log
{ level severity | state state } * |
trap { level severity | state
state } * ] *
Optional
Refer to Default Output Rules
of System
.
Configure the format of the
timestamp
info-center timestamp
{ debugging | log | trap }
{ boot | date | none }
Optional
The time stamp format for log,
trap and debugging information
is date by default.
To Next Page
Loading...
Need help?
General