1-1
1 IP Source Guard Configuration
When configuring IP Source Guard, go to these sections for information you are interested in:
z IP Source Guard Overview
z Configuring a Static Binding Entry
z Configuring Dynamic Binding Function
z Displaying and Maintaining IP Source Guard
z IP Source Guard Configuration Examples
z Troubleshooting IP Source Guard
IP Source Guard Overview
By filtering packets on a per-port basis, IP source guard prevents illegal packets from traveling through,
thus improving the network security. After receiving a packet, the port looks up the key attributes
(including IP address, MAC address and VLAN tag) of the packet in the binding entries of the IP source
guard. If there is a match, the port forwards the packet. Otherwise, the port discards the packet.
IP source guard filters packets based on the following types of binding entries:
z IP-port binding entry
z MAC-port binding entry
z IP-MAC-port binding entry
z IP-VLAN-port binding entry
z MAC-VLAN-port binding entry
z IP-MAC-VLAN-port binding entry
You can manually set static binding entries, or use DHCP snooping to provide dynamic binding entries.
Binding is on a per-port basis. After a binding entry is configured on a port, it is effective only to the port.
Enabling IP source guard on a port is mutually exclusive with adding the port to an aggregation group
and adding the port to a service loopback group.
Configuring a Static Binding Entry
Follow these steps to configure a static binding entry:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
—
To Next Page
Loading...
Need help?
General