H3C S5120-SI Series Configuration Guide

7-5
To do… Use the command… Remarks
Create a basic ACL or enter
basic ACL view
acl number acl-number
[ match-order { config |
auto } ]
As for the acl number
command, the config keyword
is specified by default.
Define rules for the ACL
rule [ rule-id ] { permit | deny }
[ source { sour-addr
sour-wildcard | any } |
time-range time-name |
fragment | logging ]*
Required
Quit to system view
quit
—
Apply the ACL while configuring
the SNMP community name
snmp-agent community
{ read | write }
community-name [ mib-view
view-name | acl acl-number ]*
Apply the ACL while configuring
the SNMP group name
snmp-agent group { v1 | v2c }
group-name [ read-view
read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl acl-number ]
snmp-agent group v3
group-name [ authentication |
privacy ] [ read-view
read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl acl-number ]
Apply the ACL while configuring
the SNMP user name
snmp-agent usm-user { v1 |
v2c } user-name group-name
[ acl acl-number ]
snmp-agent usm-user v3
user-name group-name
[ [ cipher ]
authentication-mode { md5 |
sha } auth-password
[ privacy-mode { aes128 |
des56 } priv-password ] ] [ acl
acl-number ]
Required
According to the SNMP version
and configuration customs of
NMS users, you can reference
an ACL when configuring
community name, group name
or username. For the detailed
configuration, refer to SNMP
Configuration.
Configuration Example
Network requirements
Only SNMP users sourced from the IP addresses of 10.110.100.52 and 10.110.100.46 are permitted to
access the switch.

H3C S5120-SI Series Specifications

General

Brand	H3C
Model	S5120-SI Series
Category	Switch
Language	English