ES0666 rev D 09/09
3
209 - Length of Stock - Controls the length of the raw part that will be displayed in live image. This setting
can be adjusted by entering a value in STOCK LENGTH in the STOCK SETUP tab in IPS.
210 - Jaw Height - Controls the height of the chuck jaws that will be displayed in live image. This setting can
be adjusted by entering a value in JAW HEIGHT in the STOCK SETUP tab in IPS.
211 - Jaw Thickness - Controls the thickness of the chuck jaws that will be displayed in live image. This
setting can be adjusted by entering a value in JAW THICKNESS in the STOCK SETUP tab in IPS.
212 - Clamp Stock - Controls the clamp stock size of the chuck jaws that will be displayed in live image. This
setting can be adjusted by entering a value in CLAMP STOCK in the STOCK SETUP tab in IPS.
213 - Jaw Step Height - Controls the height of the chuck jaws step that will be displayed in live image. This
setting can be adjusted by entering a value in JAW STEP HEIGHT in the STOCK SETUP tab in IPS.
214 - Show Rapid Path Live Image - Controls visibility of red dashed line representing rapid path.
215 - Show Feed Path Live Image - Controls visibility of solid blue line representing feed path in live image.
217 - Show Chuck Jaws - Controls whether the green chuck jaws will be visible in live image.
218 - Show Final Pass - Controls the visibility of a solid green line that represents a nal pass in live image.
This is shown if the program has been previously run or simulated.
219 - Auto Zoom to Part - Controls whether or not live image will auto zoom the part to the bottom left
corner. Turn on or off by pressing F4.
220 - TS Live Center Angle - Controls center angle of tailstock. Used to display the tailstock in live image.
221 - Tailstock Diameter - Controls the diameter of the tailstock. Used to display the tailstock in live image.
222 - Tailstock Length - Controls the length of the tailstock. Used to display the tailstock in live image.
224 - Flip Part Stock Diameter - Controls the new diameter location of the jaws after ipping the part
225 - Flip Part Stock Length - Controls the new length location of the jaws after ipping the part
226 - SS Stock Diameter - Controls the diameter of the part where the sub spindle clamps it.
227 - SS Stock Length - Controls the length of the sub spindle from the left of the part.
228 - SS Jaw Thickness - Controls the sub spindle jaw thickness.
229 - SS Clamp Stock - Controls the sub spindle clamp stock value.
230 - SS Jaw Height - Controls the sub spindle jaw height.
231 - SS Jaw Step Height - Controls the sub spindle jaw step height.
233 - SS Clamping Point - Controls the clamping point (the location on the part where the sub spindle
clamps it) for display purposes in Live Image. This value is also used to create a G code program that will
perform the desired sub spindle operation.
234 - SS Rapid Point - Controls the rapid point (the location to which the sub spindle rapids before clamp-
ing a part) for display purposes in Live Image. This value is also used to create a G code program that will
perform the desired sub spindle operation.
235 - SS Machine Point - Controls the machining point (the location where the sub spindle machines a part)
for display purposes in Live Image. This value is also used to create a G code program that will perform the
desired sub spindle operation.
236 - FP Z Stock Face - Controls the ip part stock face for display purposes in Live Image. This value is also
used to create a G code program that will perform the desired sub spindle operation.
237 - SS Z Stock Face - Controls the sub spindle stock face for display purposes in Live Image. This value is
also used to create a G code program that will perform the desired sub spindle operation.
To Next Page
Loading...
