Haas TL Series - Thread Re-Cut - Set Reference & Re-Cut; Grooving Mode

To Next Page

To Previous Page

ES0609 rev D 4/09

Orient SP –

Degrees –

X Position –

Z Position –

Thread Re-Cut - Set Reference & Re-Cut

Step 3 of 3

This mode is used to teach the threading tool OD or ID. Then re-cut the threads using an existing program in

program memory.

SET OFFSET & PUSH BACK THREAD TEACH POSITION SET REFERENCE&RE-CUT

REFERENCE

PGM NUMBER

X CLEARANCE

Z CLEARANCE

STEP 3OF3

XTOOL WEAR

0.0000 in

Z OFFSET

NOT SET

0.0000 in

ORIENT RPM

0.0000 in

GROOVINGMANUALSETUPTURN&FACECHAMFER&RADIUSDRILL &TAPTHREADINGTHREAD RE-CUT

Reference –

Program Number –

X Clearance –

Z Clearance –

X Tool Wear –

Z Offset –

Orient RPM –

Grooving Mode - OD Groove

This mode is for an outside diameter groove.

Haas TL Series - Thread Re-Cut - Set Reference & Re-Cut; Grooving Mode - OD Groove