Haas TL Series - Grooving Mode - Part off

ES0609 rev D 4/09
30
Press <CYCLE START> to run
in MDI or <F4> to record
output toaprogram
OD GROOVE
ID GROOVE
PART OFF PART OFF WITH PECK
TOOL NUMBER
1
WORK OFFSET
54
ZSTART PT
0.0000 in
INSIDE DIA.
0.0000 in
DIA. TO CUT
0.0000 in
0.0000 in
0.0000 in
TOOL WIDTH
0.0000 in
MAX RPM
1000
Z DIMENSION
GROOVE WIDTH
FEED PER REV
0.0000 in
200
SFM
MANUALSETUPTURN&FACECHAMFER&RADIUSDRILL &TAPTHREADINGTHREAD RE-CUTGROOVING
Tool Number – Enter the tool to be used.
Work Offset – Enter the work offset to be used.
Z Start PT – Enter the Z axis starting point.
Outside Dia – Enter the current diameter of the work piece. Manually measure the diameter.
Dia to Cut (Diameter to Cut) – Enter the nished diameter.
Z Dimension – Enter the Z-axis dimension of the groove. Entered value must be positive.
Groove Width – Enter the nished width of the groove. Entered value must be positive.
Tool Width – Enter the actual width of the tool.
Feed per Rev – Enter the feed per revolution.
MAX RPM – Enter the maximum spindle turning speed.
SFM – Enter the Surface Feed per Minute.
Advanced Users: Additional Settings may need to be modied to create the required groove. These setting
numbers are: 22, 28, 72, 73, 86. See the denitions of the setting in the Operator’s Manual. In the full CNC
mode this is a G75 command.
Grooving Mode - Part Off
This mode is for parting off.