Haas TL Series - Chamfer & Radius - I.D. Radius

ES0609 rev D 4/09
17
Radius – Enter the desired radius. This is the desired corner radius. Note that the larger the radius or material
to be removed, the more passes required to rough out the prole.
Depth of Cut – Enter depth of cut for each pass of stock removal. This is the amount of stock to be removed
on each tool pass. A pass must be less than or equal to maximum single pass cut depth for selected tool.
Feed Per Rev – Enter feed per revoultion. This is distance tool will move for each revolution of the spindle.
MAX RPM – Enter the maximum spindle turning speed.
Tool Nose – Enter the tool nose radius. This is the radius of the selected tool. Normally this information is
included with the tool.
SFM – Enter the Surface Feed per Minute.
Advanced Users: In the full CNC mode this is a G71 command.
Chamfer & Radius - I.D. Radius
This mode is used to cut an inside diameter radius.
Press <CYCLE START> to run
in MDI or <F4> to record
output toaprogram
OD RADIUS ID RADIUS
OD CHAMFER ID CHAMFER
TOOL NUMBER
1
WORK OFFSET
54
ZSTART PT
0.0000 in
INSIDE DIA.
0.0000 in
RADIUS
0.0000 in
0.0000 in
0.0000 in
MAX RPM
1000
SFM
200
DEPTH OF CUT
FEED PER REV
TOOL NOSE
0.0000 in
GROOVINGTHREAD RE-CUTTHREADINGDRILL &TAPMANUALSETUPTURN&FACECHAMFER&RADIUS
Tool Number – Enter the tool to be used.
Work Offset – Enter the work offset to be used.
Z Start PT – Enter the Z axis starting point.
Inside Dia. – Enter the current diameter of the work piece. Manually measure the diameter.