Productivity Inc – Haas CNC TL Series Lathe Operator Manual Page 51
Groove Cutting Cycle
Navigate back to the main tabs menu. Select GROOVING, then select OD GROOVE to do process
#6. Input the information the IPS is asking for, verify it cuts a good part, then use the recorder
again to record this feature.
IPS OD Groove Cycle Question Relationship To The Part
Tool Number
Part Offset
X Start Diameter
Z Face
Diam. To Cut
Groove Width
Grooving Tool Width
Feed Per Revolution
Surface Footage
Max Spindle Speed
To Next Page
Loading...
