Haas TL Series - Program Example

ES0666 rev D 09/09
2
Program Example
%
O01000;
;
G20 (INCH MODE) ; (Start of Live Image information)
(STOCK);
([0.0000, 0.1000] [[6.0000, 6.0000]) ; ([Hole Size, Face] [Diameter, Length])
(JAWS);
([1.5000, 1.5000] [0.5000, 1.0000]) ; ([Height, Thickness] [Clamp, Step Height]) (End of Live Image Information)
M01 ;
;
[Part Program]
The advantage of entering the Stock Settings into the program is that these settings may be saved with the
program, and the Stock Setup screen does not require the entry of data when the program is run in the future.
Further settings for Live Image, such as X and Z Offset, Rapid Path and Feed Path Live Image and Show
Chuck Jaws are accessed by pressing SETNG GRAPH, typing in the rst LIVE IMAGE setting (202) and
pressing the up arrow.
202 LIVEIMAGE SCALE(HEIGHT)
203 LIVEIMAGEXOFFSET
205 LIVEIMAGEZOFFSET
206 STOCK HOLESIZE
207 ZSTOCK FACE
208 STOCK OD DIAMETER
209 LENGTHOFSTOCK
210 JAW HEIGHT
211JAW THICKNESS
212 CLAMP STOCK
213 JAWSTEP HEIGHT
214 SHOW RAPIDPATH LIVEIMAGE
215 SHOW FEED PATH LIVEIMAGE
217 SHOW CHUCK JAWS
218 SHOW FINAL PASS
219 AUTOZOOM TO PART
220 TS LIVE CENTER ANGLE
221 TAILSTOCK DIAMETER
222 TAILSTOCK LENGTH
GENERAL
PROGRAM
I/O
LIVE IMAGE
POWER SETTINGSMAINTENANCE
SYSTEM
CONTROL PANEL
LIVE IMAGE
1.1050
0.0000
0.0000
0.0000
0.0500
6.5000
6.0000
3.5000
2.5000
0.2500
2.0000
OFF
OFF
ON
OFF
OFF
OFF
OFF
OFF
Settings
202 - Live Image Scale (Height) - Species the height of the work area that is displayed in the live image
screen. The maximum size is automatically limited to the default height. The default shows the machine’s
entire work area.
203 - Live Image X Offset - Locates the top of the scaling window relative to the machine X zero position.
The default is zero.
205 - Live Image Z Offset - Locates the right side of the scaling window relative to the machine X zero
position. The default is zero.
206 - Hole Size - Demonstrates the I.D. of the part. This setting can be adjusted by entering a value in HOLE
SIZE in the STOCK SETUP tab in IPS.
207 - Z Stock Face - Controls the Z stock face of the raw part that will be displayed in live image. This setting
can be adjusted by entering a value in STOCK FACE in the STOCK SETUP tab in IPS.
208 - Stock OD Diameter - Controls the diameter of the raw part that will be displayed in live image. This
setting can be adjusted by entering a value in STOCK DIA. in the STOCK SETUP tab in IPS.