Haas TL Series - Menu Option 1: Select; Create Program

ES0666 rev D 09/09
9
RAPID
FEED
FINALPASS
TO ACTIVATEZOOM MODE PRESS F2
ZOOM OFF
LIVEIMAGE SCALE: 1.111 8
CURRENT TOOL:#1-OD TURN TOOL
G71CANNED CYCLE
NOTE: Data displayed on the screen while the program is running includes: program, main
spindle, machine position and timers and counters.
Flipping a Part
A graphical representation of a part that has been ipped manually by the machinist is depicted by adding the
following comments to the program following an M00. Press F4 to enter Live Image code to the program.
VQC
SETUP
STOCK TOOL WORK
FLIP DIA.
FLIP LENGTH
3.0000 in
JAW THKNS
JAW HEIGHT
N/A
STOCK FACE
0.0500 in
HOLE SIZE
STEP HEIGHT
N/A
CLAMP STOCK
N/A
STOCK JAWS
2.0000 in N/A
N/A
TAILSTOCK
STOCK ORIENT.
FLIP PART
STOCK ORIENT.
RAPID PT.
N/A
CLAMPING PT.
N/A
MACHINE PT.
N/A
Live Image will redraw the part with a ipped orientation, and with the chuck jaws clamped at a position
specied by x and y within the comment “(CLAMP)(x y)” if the comments “(FLIP PART)” and “(CLAMP)(x y)”
follow the M00 STOP PROG instruction in the program.
O00000 ;
[Code for rst operation of Live Image]
[Code for rst operation of machined part]
M00 ;
G20 (INCH MODE); (Start of Live Image Information for ipped part)
(FLIP PART) ;
(CLAMP) ([2.000, 3.0000]) ; ([Diameter, Length]) (End of Live Image Information ipped part)
;
M01 ;
;
[Part Program for the second operation];