Productivity Inc – Haas CNC TL Series Lathe Operator Manual Page 50
Radius Cycle Menu
Many of the IPS menus are very similar to each other; all that is need is answering questions to
the control and its pictures.
Operation #5 is to turn the .250 radius on the 2.500” diameter. Navigate to the OD RADIUS Tab
and enter the information needed below:
IPS OD Radius Cycle Question Relationship To The Part
Tool Number
Part Offset
X Diameter
Radius
Depth Of Cut
Z Start
Feed Per Revolution
Surface Footage
Max Spindle Speed
Add the code created from above to the end of Program O1.
To Next Page
Loading...
