Haas TL Series - Graphic Mode

ES0609 rev D 4/09
14
i. Press Write/Enter until Z POS is selected. Jog Z to -3.0 and press Write/Enter.
j. Press F2 to Save and exit the Prole Creator.
k. Press Cycle Start to cut the prole.
NOTE: The program may be saved to memory from MDI by typing in 0xxxxx and pushing
the Alter key. This action moves the program from MDI memory.
If Graphic Mode is set to ON in the Turn & Face Prole screen, when Cycle Start is pressed to run a prole, a
graphic screen is displayed showing the graphical representation of the prole.
Graphic Mode
To cut the prole on the other side of the workpiece, set Mirror X to ON in Turn & Face Prole screen (it is not
necessary to change Mirror X in Settings). When Cycle Start is pressed, the opposite side of the workpiece is
cut, and if Graphic Mode is set to ON, a graphical representation of the mirrored prole is displayed.