Productivity Inc – Haas CNC TL Series Lathe Operator Manual Page 12
1 – Function Keys
F1 – F4 – Perform different functions depending on which mode the machine is in. Example in offsets
mode F1 will directly enter value given it into offset geometry.
X DIAMETER MEASURE – Will take machine X position ask for a diameter measurement on the part
which tool turned and put correct X Geometry in Tool Offsets page.
NEXT TOOL – In set up this will select the next tool and make a tool index.
X/Z - Toggles between X-axis and Z-axis jog modes during a set up.
Z FACE MEASURE – Used to record Z tool offsets and Z work offsets.
2 – Jog Keys
Chip FWD (Chip Conveyer Forward) – Turns the chip conveyer in a direction that removes chips from the
work cell.
Chip STOP (Chip Auger Stop) – Stops chip conveyer movement.
Chip REV (Chip Auger Reverse) – Turns the chip conveyer in reverse.
<-TS – Moves tailstock toward the spindle.
TS Rapid – Increases speed of tailstock movement when used concurrently with the other TS keys.
->TS - Moves tailstock away from spindle.
+X, -X (Axis) Selects the X axis for continuous motion when depressed.
+Z, -Z (Axis) Selects the Z axis for continuous motion when depressed.
Rapid – When pressed simultaneously with X or Z keys will move at maximum jog speed.
To Next Page
Loading...
