Haas TL Series - Threading - OD Thread Repair

ES0609 rev D 4/09
25
Chamfer – ‘0’ turns on chamfer at end of threads. ‘1’ turns off chamfer at end of threads. (Check setting 95,
96, 86, 99).
Coolant – ‘ON’ turns on machine coolant. ‘OFF’ turns off machine coolant.
Advanced Users: Additional Settings may need to be modied to create the required groove. These setting
numbers are: 22, 28, 72, 73, 86, 95, 96, 99. See the denitions of the setting in the Operator’s Manual.
In the full CNC mode this is a G76 command.
Threading - OD Thread Repair
This mode is for repairing outside diameter threads using multiple passes.
Press <CYCLE START> to run
in MDI or <F4> to record
output toaprogram
OD THREAD
ID THREAD
OD THREAD REPAIR ID THREAD REPAIR
REFERENCE
NOT SET
TPI
48.0
THRD HEIGHT
0.0131 in
TL CLEARANCE
0.1000 in
THREAD LENGTH
0.0000 in
3
0.0125 in
SPINDLE RPM
350
Z OFFSET
0.0000 in
THRDS TO CLR
DEPTH OF CUT
X OFFSET
RIGHT
CHAMFER
OFF
THREAD DIR
COOLANT
OFF
NO OF THREADS
0
TAPER
0.0000 in
0.0000 in
GROOVINGTHREAD RE-CUTMANUALSETUPTURN&FACECHAMFER&RADIUSDRILL &TAPTHREADING
Reference – Jog the tool into the threads, then press the X DIA MEAS key. 1 = reference point recorded.
TPI – Enter the number of Threads per Inch (or Threads per Millimeter).
Thread Height –
TL Clearance –
No Of Threads – Enter the number of threads from the tool to the end of the part.
Thread Length – Enter the length of the threaded portion of the part.
Threads to Clear –
Depth of cut – Enter the amount of stock to be removed on each pass.
Spindle RPM – Enter the spindle RPM.
Taper – Enter a positive value for thread taper per ft.
X Offset – Enter a value only if minor adjustments are needed in the X axis.
Z Offset – Enter a value only if minor adjustments are needed in the Z axis.
Thread Dir – Enter ‘0’ for right hand threads or enter ‘1’ for left hand threads.
Chamfer – ‘0’ turns on chamfer at end of threads. ‘1’ turns off chamfer at end of threads. (Check setting 95,
96, 86, 99).
Coolant – ‘ON’ turns on machine coolant. ‘OFF’ turns off machine coolant.
Threading - ID Thread Repair
This mode is for repairing outside diameter threads using multiple passes.