Productivity Inc – Haas CNC TL Series Lathe Operator Manual Page 27
Tool Room Lathe Safety
Emergency Stop Switch
Located on the left side of the control panel, there is a large, round, red button that is circled
with a yellow ring. This is the EMERGENCY STOP or “E-STOP” button. In the event of a un-
controlled machine condition, a crash of the machine, or any situation that requires an
immediate shut down of all axis functions, movement, spindle functions and power to the servos
of the machine, the Emergency Stop button should be used. This button is used to halt
everything on the machine immediately!
Emergency
To Next Page
Loading...
