Haas TL Series - Tool Offsets; Offset Num; TL Thickness

ES0609 rev D 4/09
4
Tool Offsets
Tool offsets are described in detail in the Operator’s manual. See the “Tool Nose Compensation” section
within the “Operation/Programming” Tab for specic instructions on Radius, Radius Wear, Taper, and Tip.
STOCK TOOL WORK TAILSTOCK
TOOL
1
TOOL TYPE
OFFSET NUM
X OFFSET
0.0000 in
Z WEAR
RADIUS
TIP
0
TOOL SHANK
0.0000 in
TL THICKNESS
INSRT THCKNES
TOOL NOSE
INSERT HEIGHT
X WEAR TOOL LENGTH FROM CENTER
0.0000 inCUT OFF
1
Z OFFSET
0.0000 in
STEP HEIGHT DIAMETER
0.0000 in
0.0000 in
0.0000 in
0.0000 in
0 deg
0.0000 in
0.0000 in
0.0000 in
0.0000 in
0.0000 in
Selected Tool: 1
Active Tool: 1
Press [TURRET FWD] or
[TURRET REV] to change the
selected tool.
Press [NEXT TOOL] to make
selected tool active.
GROOVINGGROOVINGTHREAD RE-CUTTHREADINGDRILL &TAPCHAMFER&RADIUSTURN&FACEMANUALSETUP
Tool – The current tool number. Use the turret FWD/REV or the Next Tool buttons to set-up another tool.
Tool Type – Right/Left arrows select among 16 tool types: Drill, Tap, Vert Tap, Vert Drill, End Mill, V End Mill,
Ballnose, V Ballnose, OD Turn, ID Bore, OD Groove, ID Groove, Face Groove, OD Thread, ID Thread and
Cut Off.
Offset Num –
X Offset – The X axis offset for the current tool. Press X Dia Meas to record this position.
X Wear – The amount of tool wear, in the X axis for the current tool.
Z Offset – The Z axis offset for the current tool. Press Z Face Meas to record this position.
Z Wear – The amount of tool wear, in the Z axis for the current tool.
Radius** – The tip radius of the current tool.
Tip** – Tool tip direction will be a value of 0-9. Must be entered to use Cutter Compensation
Tool Shank –
Tool Length –
Step Height –
TL Thickness –
Tool Nose – The nose radius of the current tool.
Insert Height –
From Center –
Diameter – Compensation value for part deection.
**Must be entered to use Cutter Compensation; See the Operator’s manual for information on Cutter
Compensation.